Spectracom SecureSync User Manual

The Status window displays the following settings:
Reference ID: Indicates the letters used in the Input Reference Priority table for this par-
ticular input reference.
Validity: Indicates whether the ASCII input data is present and considered valid
for Time and 1PPS references.
A green light indicates a valid reference.
An orange light indicates the reference is not considered valid.
Leap Flag: Displays whether the incoming data stream is indicating that a pending leap
second is to be added to the UTC timescale at the end of the month. See "Leap Seconds"
on page155.
Format: Indicates the configured format of the ASCII time code input data stream.
5.2.6 Network Interface Option Cards
This section contains technical information and SecureSync Web UI procedures pertaining to
option cards designed as Ethernet network interfaces using, e.g. the PTP format.
5.2.6.1 Gigabit Ethernet [1204-06]
This option card provides SecureSync with three 10/100/1000 Base-T network interfaces, in
addition to the standard 10/100 Base-T network interface.
Gigabit Ethernet [1204-06]: Specifications
Inputs/Outputs: (3) Gigabit Ethernet (10/100/1000 Base-T)
Connectors: RJ-45 (3x)
Management: Enabled or Disabled (NTP server only)
SecureSync User Reference Guide 467
APPENDIX

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)