Spectracom SecureSync User Manual

2.
In the Remote Log Server panel locate the remote server you wish to change or delete.
3.
Choose the MINUS button to delete the remote log server. Confirm by clicking OK in the
message window.
—OR—
3.
In the Remote Log Server panel, click the GEAR button to change the remote log server.
Type in a new IP address or host domain server (e.g., MyDomain.com).
Note: Clicking the Delete button in any of the Log file configuration windows does
NOT remove the chosen remote log server from the network; it merely deselects
the server as that particular log’s remote log server.
Note: In the event that a syslog server does not support listening on the standard
syslog port, you may redirect the syslog port to the desired port by utilizing built-
in port forwarding capability in network switches (search online for port for-
warding or port mapping).
4.5.2.8 Restoring Log Configurations
To restore log configurations:
1.
Navigate to the MANAGEMENT > OTHER: Log Configuration.
2.
In the Actions panel, click on the Restore Configurations button.
3.
Click the Browse button.
4.
Navigate to the directory where the configurations are stored and click Upload.
4.5 Quality Management
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
317

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)