If you do not have access to SecureSync through another admin account, the
spadmin
pass-
word must be reset via the front panel keypad or using the front panel serial port.
Resetting the "spadmin" account password via the keypad:
1.
Use the front panel LCD and the keypad to perform a RESETPW. See also "Front Panel
Keypad, and Display" on page4. (RESETPW is located in the Home/System menus).
2. You will be prompted to confirm the operation before the password is reset. The
spad-
min
account password is now reset to “admin123”.
To reset the "spadmin" account password via the serial port, or SSH:
1.
Connect a PC to the front panel serial port, and log in using an account with admin
group rights (such as the
spadmin
account).
2.
Type: resetpw <Enter>. The
spadmin
account password is now reset.
After resetting the password follow the procedure above to change the
spadmin
password in
the MANAGEMENT > OTHER: Authentication window.
4.3 Managing Users and Security
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
255
To Next Page
Loading...
