3.
The LDAP Setup window will display.
4.
There will be 5 tabs from which to choose:
Settings: This is where you set up the general LDAP Distinguished Name and Bind
settings.
Security: This is where you upload and manage the CA server certificate, CA cli-
ent certificate and CA client key.
Group: This is where you enable/disable group-based authentication.
Advanced: This is where you set up your search filter(s) and login attribute.
Servers: This is where you identify the LDAP server to be used.
LDAP Settings
Under the LDAP Settings tab, set the following parameters:
Server Type: This must be the correct type—check with your LDAP server administrator if
you are not sure which you are using. You have a choice of:
Active Directory: This will be used when the LDAP server is a Windows server.
Open LDAP: This will be used when the LDAP server is a Linux/UNIX server.
Server Base DN: Specifies the default base distinguished name to use for searches. This is
the base name to use in the database search. Typically, this is the top-level of the dir-
ectory tree structure. Your LDAP server administrator will provide this information.
Bind DN: Enter the Distinguished Name used to bind to (this is an optional field if the
database allows anonymous simple authentication). You are able to use any same level
of the tree and everything below.
The bind DN is the user that is permitted to search the LDAP directory within the
defined search base. Most of the time, the bind DN will be permitted to search the
4.3 Managing Users and Security
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
257
To Next Page
Loading...
Need help?
General
