Spectracom SecureSync User Manual

While Standard Mode is the default setting, the High-Security Level is preferred (unless you
require the extra compatibility), since High Security turns off TLSv1, which has known secur-
ity vulnerabilities.
B r o w s e r S u p p o r t
Note that the High-Security Level requires the use of current browsers – as of July 2016, the oldest
compatible clients include:
• Firefox
®
27
• Chrome
®
30
• Internet Explorer
®
11
• Safari
®
9.
(This is not an exhaustive list.)
To enable High-Security HTTPS:
1.
Navigate to MANAGEMENT > Network Setup.
2.
In the Actions Panel on the left, click on Web Interface Settings. The Web Interface Settings
window will open.
3.
Click on the tab Security Level:
4.
Read the Caution statement and verify that you meet the requirements stated.
5.
Check the box Enable High Security, and click Submit.
6.
While it is NOT necessary to close the Web UI, and restart the browser, it is recom-
mended to wait 90 seconds before continuing to use the WebUI, in order to allow the
web server software to restart in the background.
It is also possible to disable High-Security HTTPS and TLS: Follow the procedure outlined
above, but uncheck the box Enable High Security.
For more information on HTTPS certificates, see "HTTPS" on page65.
4.3 Managing Users and Security
CHAPTER 4 • SecureSync User Reference Guide Rev. 26
267

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)