PPS Source – choices are:
Message: The 1PPS on time point is extracted from the ASCII message received.
1PPS Pin: The origin of the 1PPS on-time-point is the 1PPS input connector.
Baud Rate: Determines the speed at which the input port will operate.
Data Bits: Defines the number of Data Bits for the input output.
Parity: Configures the parity checking of the input port.
Stop Bits: Defines the number of Stop Bits for the input port.
ASCII Time Code Output: Edit Window
To configure the ASCII Output, go to its Edit window. For instructions, see: "Configuring Option
Card Inputs/Outputs" on page348.
The Web UI list entries for this card are: ASCII TIMECODE RS-232 and ASCII TIMECODE RS-
485.
Note: SecureSync starts numbering I/O ports with 0 (only 1PPS and 10MHz out-
puts start at1, because of the built-in outputs).
The Output Edit window allows the configuration of the following settings:
SecureSync User Reference Guide 463
APPENDIX
To Next Page
Loading...
