Command Description
net Displays network
settings
netnum Displays the number of general-purpose network interfaces
net4 Displays IPv4 network
settings
net6 Displays IPv6 network
settings
options Displays configured options installed (if any)
oscget Displays the installed system oscillator
portget Display whether network port is enabled (for example, "portget ETH2")
portset Enable or disable a network port:
"portset x on" where "x" is the port number (for example, "ETH2")
"portset X off"
[NOTE: Available since Web UI Revision no. 5.1.2]
portstate Display the current state for a network port
ppsctrl Enable/disable individual 1PPS output signals
priorset Sets the priority of an entry in the reference priority table
radius setretry <value> Sets how many radius login retries will be attempted
radius getretry <value> Gets the number of radius login retry attempts
radius server list Lists radius servers
radius server
add
<host> <port> <key> <timeout>
Adds radius server
radius server del <id> Deletes radius server number <id>
reboot Used to warm-boot the unit without having to disconnect or reconnect power
reftable Displays reference priority table
release4 Used with DHCP to release the IPv4 address
release6 Used with DHCPv6 to release the IPv6 address
renew4 Used with DHCP to renew the assigned IPv4 address
renew6 Used with DHCPv6 to renew the assigned IPv6 address
resetpw Resets the administrator account (spadmin) password back to the default value
“
admin123
”
routes4 Displays the current IPv4 routing table(s)
routes6 Displays the current IPv6 routing table(s)
To Next Page
Loading...
Need help?
General
