Spectracom SecureSync - Page 6

1.7.8 Mechanical and Environmental Specifications
26
1.8 Regulatory Compliance
27
CHAPTER 2
SETUP
29
2.1 Overview
30
2.1.1 Main Installation Steps
30
2.2 Unpacking and Inventory
31
2.3 Required Tools and Parts
32
2.3.1 Required GNSS Antenna Components
32
2.4 SAFETY
33
2.4.1 Safety: Symbols Used
33
2.4.2 SAFETY: Before You Begin Installation
33
2.4.3 SAFETY: User Responsibilities
36
2.4.4 SAFETY: Other Tips
36
2.5 Mounting the Unit
36
2.5.1 Rack Mounting
36
2.6 Connecting Supply Power
38
2.6.1 Power Source Selection
38
2.6.2 Using AC Input Power
38
2.6.3 Using DC Input Power
39
2.7 Connecting the GNSS Input
41
2.8 Connecting Network Cables
42
2.9 Connecting Inputs and Outputs
43
2.10 Powering Up the Unit
43
2.11 Setting up an IP Address
44
2.11.1 Dynamic vs. Static IP Address
45
2.11.2 Assigning a Static IP Address
45
2.11.2.1 Assigning a New Static IP Address
46
2.11.2.2 Setting Up an IP Address via the Front Panel
48
2.11.2.3 Setting Up a Static IP Address via a DHCP Network
50
2.11.2.4 Setting Up an IP Address via the Serial Port
51
2.11.2.5 Setting up a Static IP Address via Ethernet Cable
52
2.11.3 Subnet Mask Values
53
IV
SecureSync User Reference Guide • TABLE OF CONTENTS