Static IPv4 Address: This is the unique address assigned by the net-
work administrator. The default static IP address of the SecureSync
unit is 10.10.201.1. In the format “#.#.#.#” with no leading zer-
oes or spaces, where each ‘#’ is a decimal integer from the range
[0,255].
Table 2-3:
Default IP addresses
ETH port
Default "static lease"
IP address
ETH0 10.10.201.1
ETH1 10.10.201.2
ETH2 10.10.201.3
ETH3 10.10.201.4
The default subnet is: 255.255.0.0
Netmask: This is the network subnet mask assigned by the network
administrator. In the form “xxx.xxx.xxx.xxx.” See "Subnet
Mask Values" on page53 for a list of subnet mask values.
IPv4 Gateway: The gateway (default router) address is needed if
communication to the SecureSync is made outside of the local net-
work. By default, the gateway is disabled.
DNS Primary: This is the primary DNS address to be used for this
port.
Depending on how your DHCP server is configured, this is set auto-
matically once DHCP is enabled. Alternatively, you may configure
your DHCP server to NOT use a DNS address. When DHCP is dis-
abled, DNS Primary is set manually, using the format "#.#.#.#"
2.13 Configuring Network Settings
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
59
To Next Page
Loading...
