(f) Disconnect the cold start injector connector.
(g) Disconnect the vacuum hose from the gas filter.
(h) Remove the union bolt, two gaskets and cold start
injector tube.
(i) (California and C & C)
Disconnect the EGR gas temp. sensor connector.
(j) Disconnect the EGR vacuum hoses from the air pipe
and EGR vacuum modulator.
(e) Disconnect the No.5 water by–pass hose from the
water by–pass pipe.
(k) Remove the nut, two bolts, intake chamber stay and
throttle cable bracket.
(d) Disconnect the No.4 water by–pass hose from the
union of the intake manifold.
–ENGINE MFI SYSTEM
EG2–222
To Next Page
Loading...
