4 Teaching
4.5 Editing Job
4-32
HW1485509
HW1485509
Fig. 4-8: Multi-Selection
4.5.1.1 Undo Operation
After inserting, deleting or modifying an instruction, operations can be
undone. The undo operation can be performed even after the manipulator
is moved by the test operation. However, undo operations cannot be
performed if motion instructions are inserted or edited. The undo
operation works for the last ten edited instructions only.
4.5.1.2 Redo Operation
Redo can only be used after the undo operation has been used.
4.5.1.3 Cut Operation
Toolbar button Name Description
Undo Undo reverses the most recent editing
command from Commands tab.
Toolbar button Name Description
Redo Redo reverts the effects of the undo action
Toolbar button Name Description
Cut Deletes the selected command(s) from a job
and copies command(s) to a buffer.
To Next Page
Loading...
