5 Playback
5.1 Preparation for Playback
5-3
HW1485509
HW1485509
5.1.2 Test/Run Job Panel
When the mode switch on the Smart Pendant is switched to “AUTOMATIC
(PLAY)” while displaying the Job Contents view, the Test/Run Job panel
appears.
Fig. 5-1: Test/Run Job Panel
5.1.2.1 Operation Buttons
Press and hold the button for 2 seconds to
execute the job with selected operation cycle.
Pauses at the current line of the job. The servo
power will be kept ON. The job can be
continued to run from the paused line by
pressing the “RUN” button.
Stops the job at the current line. The servo
power will be turned OFF.
To Next Page
Loading...
