8 System and YRC Controller Setting
8.6 Network
8-12
HW1485509
HW1485509
8.6.3 MAC Address
1. Go to {MENU} → {System Settings} → {Controller}.
2. {MAC Address} is under {Network}.
8.6.4 Setting IP Address
Requires Management Security
The IP Address can be set manually (static) or automatically acquired. To
have the IP address acquired automatically via the standard DHCP
protocol, select {Auto (DHCP)} as the Source. To set the IP address and
subnet mask manually, to a fixed static value, use the following.
1. Go to {MENU} → {System Settings} → {Controller}.
2. {IP Address} is under {Network}.
3. Select the {Source} as {Manual}.
4. Press {IP Address}.
– The keypad will appear.
5. Enter the IP Address and press {Enter}.
– IP Address must be 4 numbers 0-255 separated by decimals.
Ex. 10.6.3.42
– A notice will appear stating that the YRC Controller will have to be
restarted for the new IP Address to take effect.
6. Optionally set the {Subnet Mask} if the common default 255.255.255.0
is not appropriate.
IP Addresses reserved for special use should not be used
for the YRC Controller.
– 0.0.0.0 (Current Network).
– 255.255.255.255 (Limited Broadcast).
– Any IP Address starting with 127 (Loopback
Addresses).
To Next Page
Loading...
