YASKAWA YRC1000 - 14.1.2 Startup Errors

14 Startup Error
14.1 Startup Errors and Notifications
14-3
HW1485509
HW1485509
14.1.2 Startup Errors
Table 14-1: Startup Errors
Startup Error
Number
Startup Error
Message
Cause Remedy
10 Pendant network
configuration failed
Pendant network
configuration failed.
Contact a YASKAWA Representative
and provide pendant.log file.
20 Communication
between pendant
and YRC Controller
failed.
Network cable may not be
connected. IP settings
may not be set correctly on
Smart Pendant.
The Smart Pendant requires a fixed
network address to communicate with
the YRC Controller. Follow these
steps to set the IP address:
a)Reboot the YRC Controller and
pendant
b) When '...' appears on the screen,
press a membrane key
c) Select Network and then Ethernet
0
d) Ensure DHCP is not checked
e) Set the entries:
• IP address: 10.0.0.4
• Mask: 255.255.255.0
• Gateway: 10.0.0.2
f) Press OK to save
g) Use Back and Exit to resume
startup
30 YRC Controller
Unresponsive.
“Smart Pendant Option”
may be disabled. YRC
Controller may be in
Maintenance mode due to
a YRC Controller alarm.
Make sure the YRC Controller “Smart
Pendant Option” is enabled. Use the
“Software Pendant” to troubleshoot or
contact a YASKAWA Representative.
35 Software pendant is
connected.
Software pendant is
connected.
Disconnect “Software Pendant” and
reboot the YRC Controller.
40 Some of the YRC
Controller
parameters are not
compatible with
Smart Pendant.
“Smart Pendant Option” is
disabled.
Only a YASKAWA Representative can
enable Smart Pendant Option.
Contact a YASKAWA Representative
and provide pendant.log file.
50 YRC Controller
version incompatible
with the Smart
Pendant version.
YRC Controller version
incompatible with Smart
Pendant version.
Contact a YASKAWA Representative
and provide pendant.log file. Refer to
message in message box, consider
upgrading YRC Controller system
software to minimum required version.
52 Pendant software
incompatible with
configured YRC
Controller
languages.
Pendant software
incompatible with
configured YRC Controller
languages.
Contact a YASKAWA Representative
and provide pendant.log file. Only
English and Japanese are supported.
55 Reading files from
the YRC Controller
for jobs, zones, or
user frames has
failed.
Reading files from YRC
Controller for jobs, zones,
or user frames has failed.
Contact a YASKAWA Representative
and provide pendant.log file and failed
step.
57 Reading files from
pendant failed.
Reading files from pendant
failed.
Contact a YASKAWA Representative
and provide pendant.log file.
480 of 493