YASKAWA YRC1000 - 1.17.5 Security Level Settings; 1.17.5.1 Changing Passcode

1 Smart Pendant
1.17 Security Level Setting
1-35
HW1485509
HW1485509
1.17.5 Security Level Settings
1.17.5.1 Changing Passcode
The passcode for Edit and Management level can be changed. The
passcode for Safety Level must be changed using Software Pendant
(refer to chapter 12 “Software Pendant” ).
1. Operate in Management Level or higher.
2. Go to {MENU}  {System Settings}  {General}
3. Under {Security Level Settings}, select the security mode from the
pull-down list below the “Access”.
4. Tap {SET PASSCODE}.
– The entry popup appears.
5. Type in the current passcode and tap {Enter}.
– The entry popup appears again if the current passcode is correct.
6. Type in the new passcode and tap {Enter}.
– The passcode is now changed.
58 of 493