15 Alarm
15.2 Alarms & Notifications
15-6
HW1485509
HW1485509
15.2.4 User Alarm
An User Alarm is an alarm created by a user. The alarm is displayed
shown in a yellow pop-up window. One method to set the User Alarm is
using the SetUserAlarm command in the job. For further information on
User Alarms, refer to YRC1000/YRC1000micro SUPPLEMENTAL
INSTRUCTIONS FOR Smart Pendant (INSTRUCTIONS FOR INFORM
LANGUAGE) (HW1485511).
15.2.5 Notifications
The Smart Pendant will often display banner messages at the top of the
screen to display notify the user of certain pendant states and guide the
user through incompatible/error conditions. There are two primary types
of notifications on Smart Pendant:
Fig. 15-3: Notification Types
High Priority
Notifies user that a physical action is required to proceed with the
intended action. An image is typically provided to visually detail the
required action.
Standard
Notifies the user regarding incompatible states (e.g. insufficient access
level), user interactions (e.g. item copied/deleted), or screen-specific
interactions.
To Next Page
Loading...
