13 External Memory Device
13.1 Memory Device
13-1
HW1485509
HW1485509
13 External Memory Device
13.1 Memory Device
Memory devices allow operators to save and load data such as jobs and
parameters. The following memory devices can be used with the YRC
Controller.
– USB memory stick to Smart Pendant
(The Smart Pendant is equipped with a connector.)
– USB memory stick to the YRC Controller
(The CPU board (JANCD-ACP01) is equipped with a connector.)
13.1.1 USB Memory Stick
The Smart Pendant and CPU board (JANCD-ACP01) is equipped with a
USB connector. Use the FAT16 or FAT32 formatted USB memory stick for
the CPU board, and use the FAT32 formatted USB memory stick only for
the Smart Pendant.
13.1.2 Recommended USB Memory Stick
Refer to chapter 9.1.2 “Device” of the INSTRUCTIONS of the YRC
Controller for recommended external memory devices to use with YRC
Controller.
13.1.3 Notes on Handling USB Memory Stick
– Do not drop or bend or apply any electric shock or strong force to
the USB memory stick.
– Keep away from water, oil, organic solvent, dust, dirt, and other
potential contaminants.
– Do not use or keep the USB memory stick in places where strong
static electricity or electronic noise may occur.
– Do not insert or remove the USB memory stick or turn the power
OFF when reading or writing from the USB memory stick.
– To protect data, back it up regularly on other media. This will
minimize damage to or loss of data due to operation errors and
accidents.
*USB memory sticks have a limited life span, which varies by make and
condition. Normal use of a USB memory stick as an external memory
device for the YRC Controller does not adversely affect USB memory stick
performance. For details, refer to the instruction manuals for each
medium.
To Next Page
Loading...
