1 Smart Pendant
1.5 Connection of the Smart Pendant
1-4
HW1485509
HW1485509
1.5 Connection of the Smart Pendant
For information on setup, installation, and connection of the YRC
Controller, refer to the INSTRUCTIONS of the YRC Controller.
1.5.1 Connecting to the YRC Controller
Connect the Smart Pendant cable to the connector (-X81) on the door
lower right side of the YRC Controller cabinet.
Fig. 1-3: Connection of Smart Pendant Cable to the YRC Controller
The YRC Controller has the main power switch and the door lock that are
located in the upper left on the front panel. The Emergency Stop button is
installed in the upper right of the front panel (some models do not have
this button), and the Smart Pendant can be hung from a hook below the
button.
Fig. 1-4: YRC1000 Front View with Smart Pendant
Primary power
Supply cable
Emergency Stop
button (some mo
do not have this
Main power switch
Door lock
WARNING
• Do not remove the Smart Pendant cable while the YRC
Controller is powered on.
Failure to observe this instruction may result in fire and/or electric
shock.
To Next Page
Loading...
