3 Managing Jobs
3.5 Modifying Job
3-10
HW1485509
HW1485509
3.5.3 Modifying Comment
1. Tap on the Comment
Fig. 3-7: Modifying Comment
2. Edit using the entry popup.
3. Press {Enter} on the keypad.
For details on Comment, refer to chapter 3.1.1.3 “Setting the Comment”.
3.5.4 Setting Default Job
The Default Job is a job specially designated so that can be triggered by
an external I/O signal. There can only be one Default Job per YRC
Controller. It will be shown in the Job List. The Default Job cannot be
deleted. However, another job can be set as the new Default Job.
Fig. 3-8: Setting Default Job
To Next Page
Loading...
