12 Software Pendant
12.2 Software Pendant Installation
12-3
HW1485509
HW1485509
12.2 Software Pendant Installation
12.2.1 Export Software Pendant Application from Smart Pendant
The Software Pendant application installer is stored internally on the
Smart Pendant. This installer file can be exported to a USB drive using
the following steps:
1. Navigate to {Menu}{System Settings}{General}.
2. Switch operation mode to MANUAL (TEACH).
3. Insert a USB drive with sufficient free space in to the Smart Pendant.
4. Toward the bottom of the {General Settings} screen is an {Export}
under {Bundled Resources}. Select the check box for “Software
Pendant” Application and then press the {Export} as shown below:
5. The Software Pendant installer will be copied to the USB drive.
6. Remove the USB drive and then use it to install Software Pendant on a
PC as described in the next section.
12.2.2 Install Software Pendant for YRC Controller on PC
1. Open folder “Pendant\SoftwarePendantInstall\YRC controller”.
2. Select and double-click “setup.exe”.
3. Follow the instructions: press “Next”.
To Next Page
Loading...
