8 System and YRC Controller Setting
8.3 Pendant Software
8-5
HW1485509
HW1485509
8.3 Pendant Software
The information on the Smart Pendant is shown under Pendant Software.
The following items are displayed:
Version
Release
Pendant ID
USB ID
Update Pendant Software
8.3.1 Version
The software version of the Smart Pendant that is used appears. When
the pendant software is updated by following the procedure in the chapter
8.3.5 “Update Pendant Software”, the version number will be changed to
the updated version number.
8.3.2 Release
The released date of the installed pendant software version is shown.
8.3.3 Pendant ID
Each Smart Pendant has a unique ID number, useful for identifying it to
support personnel and in log files.
8.3.4 USB ID
The serial number of any USB storage device currently inserted is shown
here. This can be used to tie license files to specific USB storage devices.
8.3.5 Update Pendant Software
The Smart Pendant's software can be updated to a newer version by
connecting the official YASKAWA update USB storage device.
1. Connect the USB storage device to the Smart Pendant.
– USB port is located on the back-side of the pendant (bottom-right
corner).
2. Press the {UPDATE PENDANT SOFTWARE} on the screen.
– Pendant will start updating.
– Do not disconnect the USB storage device until the pendant restarts.
– Pendant will automatically restart.
For more information on an USB storage device, refer to chapter 13
“External Memory Device” .
1
2
3
4
5
To Next Page
Loading...
