8 System and YRC Controller Setting
8.6 Network
8-11
HW1485509
HW1485509
8.6 Network
To access the Networking settings screen, go to
{MENU} → {System Settings} → {Controller}
Fig. 8-4: Network Setting Screen
8.6.1 YRC1000 Network
The YRC1000 has three network ports:
The network ports are located in the CPU Unit of the YRC1000. Refer to
chapter 12.3.1 “Wiring” for the location of the network ports in YRC1000.
8.6.2 YRC1000micro Network
The YRC1000micro has two network ports: CN105 (LAN1) and CN106
(LAN2). The functions supported by these ports are similar to YRC1000
as described in chapter 8.6.1 “YRC1000 Network”.
Table 8-1: Network Port for the YRC1000
Port Channel Description
LAN1 CN105 This port is used for pendant connection and is not
available for application use.
LAN2 CN106 This port is for customer application use. The IP
settings of this port can be configured as per user
requirements.
LAN3 CN107 This port is for customer application use. The IP
settings of this port can be configured as per user
requirements. Software Pendant is required to view or
configure the IP settings for CN107 (LAN3).
To Next Page
Loading...
