4 Teaching
4.5 Editing Job
4-36
HW1485509
HW1485509
2. Enter values for desired parameters and press {SAVE}.
– In the following example, the Joint Speed is set to 50.00, the Linear
Speed is set to 250.00, and the Deceleration is set to 25.
• A value is not entered for Position Level which means this
parameter will be unaffected by the changes.
Fig. 4-12: Multi-Selection Edit Parameter Values
– The code displays the updated values.
Fig. 4-13: Updated Values in Displayed Code
• The Multi-Edit popup contains {Select All Job Lines} which
expands the Multi-Selection to include the entire job.
– This is useful for quickly editing large jobs.
To Next Page
Loading...
