1 Smart Pendant
1.7 Display and Operating Elements
1-8
HW1485509
HW1485509
– GO TO POINT
When the [GO TO POINT] is pressed and a
motion instruction is selected in the Job
Contents view, the manipulator moves to the
selected position. Only available in MANUAL
(TEACH) mode.
– RUN
When pressed in AUTOMATIC (PLAY) mode, a
taught job is played back. In MANUAL
(TEACH) mode, the taught job is played back
as long as the button is pressed and held down.
– PAUSE
When pressed in AUTOMATIC (PLAY) mode,
the playing job can be paused at the current
position. Press [RUN] to restart.
– Jog Key
Moves a specific axis or Tool Center Point
(TCP) coordinate of the manipulator. An
indicator panel will show on the screen next to
the jogging keys to show what each set of keys
is controlling when the jog mode is changed.
• The manipulator operates only while the key
is pressed.
• By pressing two or more keys
simultaneously, multiple axes can be
operated at the same time. (Except when
Plus and Minus is for the same pair)
• The manipulator operates in the selected
coordinate system at the selected jogging
speed. Before operating the axis, make sure
that the selected coordinate system and the
jogging speed are set as intended.
– Jogging Speed Key
The FAST and SLOW Keys toggle through the
jogging speed settings; LOW, MED, HIGH, TOP.
The user can see the jog speed setting change
on the Status Bar.
NOTE: Pressing the [FAST] and [SLOW] membrane
keys simultaneously will trigger a screenshot if a USB
storage device is present.
To Next Page
Loading...
