ADTRAN Total Access 5000 - Delete an Existing User Account

Section 3, Common Provisioning - Configure Local User Accounts
65K510DEP08-1A 3-25
NOTE
Ifnochangetothepasswordisrequired,steps4‐5areoptional.
4. FromtheUserConfigurationprompt,type
password,andpressENTERtoaccessthe
PasswordEntryprompt.
5. FromthePasswordEntryprompt,typethenewpasswordfortheuser,andpress
ENTER.
NOTE
Ifnochangetotheprivilegelevelisrequired,step6isoptional.
6. FromtheUserConfigurationprompt,type
privilege [admin|config|read-
only|read-write|test]
,andpressENTERtosettheuserprivilegelevel.
7. FromtheUserConfigurationprompt,byperformingoneofthefollowingcommands:
•Type
no disable,andpressENTERtoenabletheusername
•Type
disable,andpressENTERtodisabletheusername
8. Type
end,andpressENTERtoreturntotheEnableprompt.
Delete an Existing User Account
TodeleteanexistinguseraccountontheTotalAccess5000,completethefollowingprocedure:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
security,andpressENTERtoaccessthe
SecurityConfigurationprompt.
3. FromtheSecurityConfigurationprompt,type
nousername WORD,andpress ENTERto
deletetheaccount.
4. Type
end,andpressENTERtoreturntotheEnableprompt.