ADTRAN Total Access 5000 - Map Example

Total Access 5000 Business Services Deployment Guide
4-26 65K510DEP08-1A
f. L2CP:Thisconfiguresthemaptopassonlylayer2controlprotocoltraffic.To
enable,type
match l2cp.Toremovethisfromthematchcriteria,typeno match
l2cp
.
4. FromtheEVC‐MapConfigurationprompt,enablethemapbytyping
no shutdown,and
press
ENTER.
5. Type
exitandpressENTERtoreturntotheGlobalConfigurationprompt.
6. Type
exitandpressENTERtoreturntotheEnableprompt.
7. Tosavethechangestonon‐volatilememory,type
write,andpressENTER.
8. FromtheEnableprompt,viewthenewmapbytypingshow evc-map WORD,andpress
ENTER.
ThiscommandalsodisplaystheEVCandUNIthatthemapisattachedto.
Oncethisprocessiscompleted,datacanberunthroughthesystem.
Map Example
Thefollowingisasampleoutputoftheshowinterfacesmapcommandformap‐2010.
MyNV838#show evc-map my_test_map
Admin State : Enabled
EVC-map Status : Running - Enabled
Connected EVC : evc2010
Policer : None
Connected UNI : Ethernet 1/0/1
Match Traffic Type : Broadcast
Match Traffic Type : Multicast
MyNV838#