ADTRAN Total Access 5000 - Log on to the Total Access 5000

Total Access 5000 Business Services Deployment Guide
3-2 65K510DEP08-1A
Log On to the Total Access 5000
Forinitialdeployment,onlycraftaccessisavailable.AserialcablewithamaleDB‐9connector
ontheTotalAccess5000endisrequired.
TologontotheTotalAccess5000commandlineinterface,completethefollowing:
1. SettheparametersoftheVT100terminaltothefollowingsettings:
• 9600baud
rate
•8‐databits
•Noparity
•1‐stopbit
•Noflowcontrol
2. PlugthemaleendofthedatacableintotheTotalAccess5000.Makeaconnectiontothe
VT100terminaloraPCrunningemulationsoftwareasappropriatefortheequipment.
3. Aftercompletingtheprerequisiteproceduresabove,pressinganykeydisplays
thelogon
prompt.
TheTotalAccess5000SystemLogonpromptdisplaysthefollowinginformation:
User Access Verification
Username:
NOTE
Theaccountnameandpasswordarecasesensitive.
Defaultac countsareAD MIN,READONLY,READWRITE,andTEST.The
defaultpasswordforeachoftheseaccountsisPASSWORD.Theprivilegeto
change passwords, account names, andprivileges areincludedin the
ADMINaccount.Atthe
Usernamefield,inputtheUsername(ADMIN),and
pressENTER.
4. Atthe
Passwordfield,inputthePassword(PASSWORD),andpressENTER.
5. Uponenteringthecorrectpassword,theTotalAccess5000CLIintroductionbanner
displaysthefollowinginformation:
User Access Verification
Username:ADMIN
Password:********
Last Login Date : Nov 10 2008 10:19:17
Last Login Type : IP Session(CLI) - 192.168.1.3
Login Failures : 0 (Since Last Login)
: 14 (Total for Account)
TA5000>
6. Typeenable,andpressENTERtoenabletheprivilegedcommands.
TheTotalAccess5000systemdisplaysthefollowinginformation:
TA5000>enable
TA5000#