ADTRAN Total Access 5000 - Add Node to a Complete Ring; Figure M-3. Add;Remove Node Illustration

Total Access 5000 Business Services Deployment Guide
M-4 65K510DEP08-1A
Add Node to a Complete Ring
NOTE
Markthefibersbeforeremovinganyfi bers.Identifynewfibersandmark
accordingly.PerformanOTDRtomakesurethefiberspanis cleanandnote
anyTXandRXvalues.
FigureM‐3assumesthatathree‐noderingexists.Afourthnode(D)isbeingaddedtothering.
Figure M-3. Add/Remove Node Illustration
ToaddaNodetoacompletering,completethefollowing:
NOTE
•Thisprocessassumesthatathree‐noderingexistsandthatafourthnodeis
beingadded.Th efirstnodewillbeidentifiedasA,these condnodeasB,
thethirdnodeasC,andthenewnodeasD.
•FormoreinformationonperformingaManualorForced
Switch,referto
“PerformaManualorForcedSwitch”onpage M‐2.
1. LogontoNodeCandperformaManualSwitchontheEastInterface.
AManualSwitchchecksifanyfaultsexistonthering.Ifanyfaultsexistonthering,the
ManualSwitchisrejected.
FigureM‐4displaystheCurrent
WestProtectionmenu.
10.0.80.10
Total Access
5000 Host
(Node A)
10.0.80.10
Total Access
5000 to be
Added (Node D)
10.0.80.20
Total Access
5000 (Node B)
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
10.0.80.30
Total Access
5000 (Node C)
West East