ADTRAN Total Access 5000 - NCTE B Configuration; NCTE Ethernet OAM Example Using Component 2; NCTE a Configuration

Appendix C, Ethernet OAM Provisioning - Ethernet OAM on the NetVanta 800/8000 Series NCTE
65K510DEP08-1A C-9
component 1 vlan 1010
exit
exit
exit
interface efm-group 1
ethernet cfm mep 2000 MD_5 MA_1010 down
ccm-enabled
no shutdown
exit
NCTE B Configuration
ethernet cfm
ethernet cfm domain char-string MD_5 level 5
association char-string MA_1010
remote-mep 2000
component 1 vlan 1010
exit
exit
exit
interface efm-group 1
ethernet cfm mep 2001 MD_5 MA_1010 down
ccm-enabled
no shutdown
exit
NCTE Ethernet OAM Example Using Component 2
Inthefollowingexample,theuseriscreatingalevel6MDinthecustomernetworkwhichis
encapsulatedbyans‐tagandistransparentacrosstheprovidernetwork.UpMEPswill
transmit/receiveCFMmessageswiththec‐tagdefinedbyComponent2oftheMaintenance
Association.Duetothe
rulesoftheEVCandEVC‐map,thesemessageswillhavethes‐tag
stackedbeforeegressingtheMEN‐port.FortheUpMEPstobecomeactive,theEVC‐map
matchingonCE‐VLAN‐ID200mustbeintheRunningstate.TheMAhastwoendpoints
(NCTEAand
NCTEB).TheuseriscreatingasingleMAwithVLAN200.NCTEAhasaMEP
withaMEPIDof600andNCTEBhasaMEPwithaMEPIDof601.TheCCMintervalisnot
explicitlyconfiguredsothedefaultCCMintervalof1‐secondwillbeused.
NCTE A Configuration
evc evc1010
s-tag 1010
connect men-port efm-group 1/0/1
no shutdown