ADTRAN Total Access 5000 - Set the Date and Time; Provision the SNMP Interface

Section 3, Common Provisioning - Set the Date and Time
65K510DEP08-1A 3-3
NOTE
Theprivilegedcommands(Enableprompt)aredesignatedbythe#prompt.
Set the Date and Time
Tosetthedateandtime,completethefollowing:
1. FromtheEnableprompt,type
config term,andpressENTER.
2. FromtheGlobalConfigurationprompt,type
clock set <HH:MM:SS> <1-31> WORD
<2000-2036>
,andpressENTER.
3. Type
exit,andpressENTERtoreturntotheEnableprompt.
Provision the SNMP Interface
TheSNMPinterfaceisconfiguredtoprovidealmostallitemsaccessiblethroughtheTotal
Access5000CLI.Statusandperformancemonitoringparametersareread‐onlyelements,
whereasconfigurationitemsareread‐write.Theonlyitemsthatmaynotbechangedthrough
SNMParenetworkmanagementelementsthatwouldinterferewithproper
operationofthe
EthernetorInbandinterfaces,suchasIPaddresses,defaultroutes,etc.
NOTE
TheSNMPinformation isrequiredinorderfortheTotalAccessEMSto
interfacewiththeTotalAccess5000.
ToprovisiontheSNMPinformation,completethefollowing:
1. FromtheEnableprompt,type
config termandpressENTERtoaccesstheGlobalCon‐
figurationprompt.
2. FromtheGlobalConfigurationprompt,type
snmp-server host A.B.C.D,andpress
ENTERtoaddanSNMPserverentrytotheTotalAccess5000.
3. FromtheGlobalConfigurationprompt,type
snmp-server chassis-id WORDtoset
theSystemName,andpress
ENTER.
NOTE
The chassis nameis entered usingup to 55alpha‐numericcharacters
beginningwithalettercharacter withnospacesallowed.
4. FromtheGlobalConfigurationprompt,type
snmp-server location WORDtosetthe
SystemLocationtothedesiredlocationname,andpress
ENTER.
NOTE
TheSNMPserverlocationallowsspaces,specialcharacters,andupperand
lowercasecharacters.TheSNMPserverlocationislimitedto 55alpha‐
numericcharacters.