ADTRAN Total Access 5000 - Provision the Uplink Identifier

Appendix J, GigE Star Provisioning - Central Office Terminal (COT) Provisioning
65K510DEP08-1A J-5
1. FromtheTotalAccess5000Mainmenu,selectSystem CLI,andpressENTER.
2. FromtheCLImenu,select
CLI Command Entry,andpressENTER.
Thefollowingresponseisdisplayed:
Use EXIT to exit CLI session.
3. SelectYtoentertheCLIcommandinterface.
4. LoginagainusingthedefaultADM IN andPASSWORDoptions.TheCLIpromptis
displayed.
5. Type
enable,andpressENTERtoenabletheprivilegedcommands.
6. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccessthe
GlobalConfigurationprompt.
7. FromtheGlobalConfigurationprompt,provisionthemoduleadministrationstateby
performingoneofthefollowingcommands:
•Type
no slot shutdown <shelf/slot>,andpressENTERtotakeaslotInService
•Typeslot
shutdown maintenance <shelf/slot>,andpressENTERtotakeaslot
OutofService,Maintenance
•Type
slot shutdown <shelf/slot>,andpressENTERtotakeaslotOutofService,
Unassigned
8. FromtheGlobalConfigurationprompt,type
interface t3 <shelf/slot/port>,and
press
ENTER.
9. Provisiontheportadministrationstatebyperformingoneofthefollowingcommands:
•Type
no shutdown,andpressENTERtotakeaportInService
•Type
shutdown maintenance,andpressENTERtotakeaportOutofService,Mainte‐
nance
•Type
shutdown,andpressENTERtotakeaportOutofService,Unassigned
Provision the Uplink Identifier
Toprovisiontheuplink identifier,completethefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
ethernet default interface efm-
group WORD
,andpressENTER.
NOTE
UsetheWORDinputtoenterastringwithoutspaces.Thisinputiscase
sensitive.
WORDisthegroupnameassignedwhenconfiguringtheEFMgroupusingEZ‐EFM.