ADTRAN Total Access 5000 - System Timing Configuration for Remote Terminal Node

Appendix N, ERPS Provisioning - ERPS Configuration
65K510DEP08-1A N-5
7. FromtheSystem‐TimingConfigurationprompt,typesource primary external
primary
,andpressENTER.
8. FromtheSystem‐TimingConfigurationprompt,type
exit,andpressENTER.
9. Ifnecessary,repeatsteps3‐6,replacingprimarywithsecondary,forasecondary
externalsource.
System Timing Configuration for Remote Terminal Node
ToconfigurethesystemtimingfortheRemoteTerminalNode,completethefollowing:
1. LogontotheRemoteTerminalNode.
2. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccessthe
GlobalConfigurationprompt.
3. FromtheGlobalConfigurationprompt,type
system-timing 1,andpressENTER.
4. FromtheSystem‐TimingConfigurationprompt,type
source primary interface
ten-gigabit-ethernet 1/A/2 fixed
,andpressENTER.
5. FromtheSystem‐TimingConfigurationprompt,type
source secondary interface
ten-gigabit-ethernet 1/B/2 fixed
,andpressENTER.
6. FromtheSystem‐TimingConfigurationprompt,type
revertive hop-count,and
press
ENTER.
7. FromtheSystem‐TimingConfigurationprompt,type
exit,andpressENTER.