ADTRAN Total Access 5000 - Create a Link Aggregation Group; Enable LACP; Enable Network Interfaces

Appendix A, Link Aggregation Guide - Link Aggregation Provisioning
65K510DEP08-1A A-3
Enable Network Interfaces
ToenableanySMGigabit‐Ethernetports:
1. FromtheEnableprompt,type
configure terminalandpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet
<shelf/slot/port>
,andpressENTERtoaccesstheGigabitEthernetInterface
Configurationprompt.
3. FromtheGigabitEthernetInterfaceConfigurationprompt,type
no shutdown,and
press
ENTERtosettheinterfacetoInService.
4. Repeatsteps2to3toenableadditionalgigabit‐ethernetinterfaces
5. FromtheGigabitEthernetInterfaceConfigurationprompt,type
end,andpressENTERto
returntotheEnableprompt.
Create a Link Aggregation Group
Tocreatealinkaggregationgroupandassignphysicalinterfaces,completethefollowing
procedure:
1. FromtheEnableprompt,type
configure terminalandpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface lag-group 1/A/1,andpress
ENTERtocreatethelinkaggregationgroupandaccessthelaggroupconfigurationprompt.
3. FromtheLinkAggregationGroupInterfaceConfigurationprompt,type
active-
links-minimum <1-n>
,andpressENTERtosettheminimumnumberofactivelinksfor
thegroup.
4. FromtheLinkAggregationGroupInterfaceConfigurationprompt,type
link
gigabit-ethernet <shelf/slot/port>
,andpressENTERtoaddagigabit‐ethernet
interfacetothegroup.
5. Repeatstep4toaddallneededinterfacestothegroup.
6. FromtheLinkAggregationGroupInterfaceConfigurationprompt,type
no shutdown
andpress
ENTERtoenablethelinkaggregationgroup.
7. FromtheLinkAggregationGroupInterfaceConfigurationprompt,type
endandpress
ENTERtoreturntotheEnableprompt.
8. FromtheEnableprompt,type
show lag-group 1,andpressENTERtoseethelink
aggregationgroupsinthesystem.
Enable LACP
ToenableLACPforallactivegigabit‐ethernetports,completethefollowingprocedure:
1. FromtheEnableprompt,type
configure terminalandpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet <1/
slot/port>
,andpressENTERtoaccesstheGigabitEthernetInterfaceConfiguration
prompt.