ADTRAN Total Access 5000 Deployment Guide

Section 6, EoTDM Provisioning - Create an EVC Map
65K510DEP08-1A 6-23
Modify an Existing EFM Group
ToaddalinktotheEFMgroupattheNetVanta800,completethefollowing:
1. FromtheEnableprompt,typeconfigureterminal,andpressEntertoaccesstheGlobal
Configurationprompt.
2. FromtheGlobalConfigurationprompt,accesstheDS1port’sconfigurationpromptby
typing
no shutdown,andpressENTER.
3. FromtheSHDSLInterfaceConfigurationprompt,enablethedownDS1portsbytyping
no shutdown, andpressENTER.
4. Repeatsteps2to3fortheremainingDS1portstobeaddedtotheEFMgroup.
5. FromtheT1InterfaceConfigurationprompt,type
exit,andpressENTERtoreturntothe
GlobalConfigurationprompt.
6. FromtheGlobalConfigurationprompt,type
interface efm-group 1/0/1,andpress
ENTERtoaccesstheEFMBondingGroupConfigurationprompt.
7. AddtheDS1porttothebondinggroupbytyping
link 0/<port>,andpressENTER.
8. Repeatstep7toaddalldesiredportstotheEFMbondinggroup.
9. Type
end, andpressENTER toreturntotheEnableprompt.
Remove an Existing Link
ToremovealinkfromtheEFMgroupattheNetVanta800,completethefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,accesstheDS1port’sconfigurationpromptby
typing
interface t1 1/0/<port>,andpressENTER.
3. FromtheT1InterfaceConfigurationprompt,shuttheDS1portdownbytyping
shutdown,andpressENTER.
4. Repeatsteps2to3fortheremainingDS1portstoberemovedfromtheEFMgroup.
5. FromtheT1InterfaceConfigurationprompt,type
exit,andpressENTERtoreturntothe
GlobalConfigurationprompt.
6. FromtheGlobalConfigurationprompt,type
interface efm-group 1/0/1,andpress
ENTERtoaccesstheEFMBondingGroupConfigurationprompt.
7. RemovetheDS1portfromthebondinggroupbytyping
no link 0/<port>,andpress
ENTER.
8. Repeatstep7toremovealldesiredportsfromtheEFMbondinggroup.
9. Type
end, andpressENTER toreturntotheEnableprompt.

ADTRAN Total Access 5000 Specifications

Interfaces

craft interface	DB-9 RS-232 Electrical Interface (Async)
admin interface	DB-9 RS-232 DTE Electrical Interface (Async with Modem Control Signals)
network management port	DB-9 RS-232 DTE Electrical Interface (Async)
ethernet interface	10Bt
external alarm inputs	16

Operating Environment

operating temperature	-40°C to +65°C
storage temperature	-40°C to +70°C
relative humidity	Up to 95%, non-condensing

Weight and Dimensions

height	9.25 in.
width	0.08 in.
depth	9.5 in.
weight	0.6 lbs.