ADTRAN Total Access 5000 Deployment Guide

Section 5, BSM Provisioning - Create a Point-To-Point Protocol Group
65K510DEP08-1A 5-7
4. FromtheT1InterfaceConfigurationprompt,typedescription LINE,andpressENTER
toconfiguretheCircuitID.
5. FromtheT1InterfaceConfigurationprompt,type
framing [d4|esf],andpressENTER
toselecttheframingmode.
6. FromtheT1InterfaceConfigurationprompt,provisiontheT1portadministrationstate
byperformingoneofthefollowingcommands:
•Type
no shutdown,andpressENTERtotakeaportInService
•Type
shutdown maintenance,andpressENTERtotakeaportOutofService,Mainte‐
nance
•Type
shutdown,andpressENTERtotakeaportOutofService,Unassigned
7. Type
end,andpressENTERtoreturntotheEnableprompt.
Create a Point-To-Point Protocol Group
Thissectiondetailsthefollowinginformation:
• DefinitionofaPPPgroup
•Stepsforcreatingandconfiguring thePPPgroup
•PPPexample
•StepsforaddingalinktothePPPgroup
PPP Group Definition
CreatingaPPPgroupprovidesawaytobond,orjoin,severalphysicallinks,suchasmultiple
T1s,intoasinglegroup.Aspartofthecreation,apeerIPaddress,defaultgateway,andDNS
addressesareassignedtothegroup.
PPPisusedinnetworkingandisadatalink
protocolthattransportsdatapackets between
twonetworkingnodesviaasimultaneous,bi‐directionalconnectionoversynchronousand
ansynchronouscircuits.The datapacketsaredeliveredinorderandcanbeusedoveravariety
ofhosts,ornetworklayerprotocols.
PPPdependsontwoseparateprotocolsforoperation:LCPandNCP.
LCPisnecessaryto
verify,configure,andtestthelinkconnections.NCPisanassemblyofprotocolsusedtoverify
andconfigurethevarietyofnetworklayerprotocolsoverwhichPPPcanbeused.PPPisalso
capableofbeingusedoversuchphysicalnetworksasserialcable,phoneline,and
trunkline.
PPPisusedbyInternetServiceProviders(ISPs),whichuseencapsulatedformsofPPPto
accessDigitalSubscriberLine(DSL)internet,whicharePoint‐to‐PointProtocoloverEthernet
(PPPoE)andPoint‐to‐PointProtocoloverATM(PPPoA).

ADTRAN Total Access 5000 Specifications

Interfaces

craft interface	DB-9 RS-232 Electrical Interface (Async)
admin interface	DB-9 RS-232 DTE Electrical Interface (Async with Modem Control Signals)
network management port	DB-9 RS-232 DTE Electrical Interface (Async)
ethernet interface	10Bt
external alarm inputs	16

Operating Environment

operating temperature	-40°C to +65°C
storage temperature	-40°C to +70°C
relative humidity	Up to 95%, non-condensing

Weight and Dimensions

height	9.25 in.
width	0.08 in.
depth	9.5 in.
weight	0.6 lbs.