ADTRAN Total Access 5000 - Delete a PPP Group

Section 5, BSM Provisioning - Create a Point-To-Point Protocol Group
65K510DEP08-1A 5-9
5. FromthePPPGroupprompt,typepeer default ip address A.B.C.D,andpress
EntertosetthePPPgrouppeerIPaddress.
NOTE
A.B.C.DistheIPaddressofthesubtende ddevice.
6. FromthePPPGroupprompt,type
peer default ip default-gateway A.B.C.D,
andpress
ENTERtosetthePPPgrouppeerdefaultgatewayaddress.
NOTE
A.B.C.DistheIPaddressofthedefaultgateway.
7. FromthePPPGroupprompt,type
peer default ip dns A.B.C.D E.F.G.H,and
press
ENTERtosetthePPPgrouppeerDNSaddresses.
NOTE
A.B.C.DistheIPaddressoftheprimaryDNSandE.F.G.HistheIPaddressof
thesecondaryDNS.SpecifyingthesecondaryDNSisoptional.
8. FromthePPPGroupprompt,type
no shutdown,andpressENTERtoactivatethePPP
group.
9. FromthePPPGroupprompt,type
end,andpressENTER toreturntotheEnableprompt.
ThePPPgroupisnowcreated.
10. FromtheEnableprompt,type
show interfaces ppp-group <shelf/slot/group>,
andpress
ENTERtoviewthePPPgroupconfigurat ionandstatus.
Delete a PPP Group
TodeleteaPPPgroup,completethefollowingsteps:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
no interface ppp-group <shelf/
slot/group>
,andpressENTERtodeletethe s pecifiedPPPgroup.
3. FromtheGlobalConfigurationprompt,type
end,andpressENTERtoreturntotheEnable
prompt.