ADTRAN Total Access 5000 - Provision the T1 8-Port Line Module; • Provision the Timing Source; • Provision the Uplink Identifier

Appendix J, GigE Star Provisioning - Remote Terminal (RT) Provisioning
65K510DEP08-1A J-15
Provision the T1 8-Port Line Module
Thissubsectiondetailsthefollowing information:
•ProvisiontheTimingSource
•ProvisiontheUplinkIdentifier
Provision the Timing Source
ToprovisiontheT18‐Porttimingsource,completethefollowing:
1. FromtheProvisioningmenu,select
EFM Setting,andpressENTER.
2. FromtheEFMSettingsmenu,select
Timing,andpressENTER.
3. FromtheTimingmenu,select
LoopA Timing Source,andpressENTER.
4. FromtheLoopATimingSourcemenu,selecttherequiredoption,andpressEnter.
Thismenucontainsthefollowingoptions:
•SelectDS1:ThissettingallowstheentryoftheDS1timingsource.Thevalidsettings
arefrom1–8.
• None:Whenselected,thisoptiondoesnotsetthetimingsourcetotheDS1.Timing

defaultstothetimingsetintheGigESM.
5. FromtheTimingmenu,select
LoopB Timing Source,andpressENTER.
6. FromtheLoopBTimingSourcemenu,selecttherequiredoption,andpressEnter.
Thismenucontainsthefollowingoptions:
•SelectDS1:ThissettingallowstheentryoftheDS1timingsource.Thevalidsettings
arefrom1–8.
• None:Whenselected,thisoptiondoesnotsetthetimingsourcetotheDS1.Timing

defaultstothetimingsetintheGigESM.
Provision the Uplink Identifier
TheuplinkidentifiersettingsdependoniftheNodesarebeingconnectedbywayoftheEFM
card.
Tosettheuplinkidentifierfor RTNode,completethefollowing:
1. FromtheProvisioningmenu,select
EFM Setting,andpressENTER.
2. FromtheEFMSettingmenu,select
Uplink Identifier,andpressENTER.
3. FromtheUplinkIdentifierSystemmenu,select
Select EFM Group,andpressENTER.
4. FromtheSelectEFMGroupmenu,entertheselectedEFMgroup,andpress
ENTER.