ADTRAN Total Access 5000 - Provision the Ethernet Star; Provision the Network Ports

Appendix J, GigE Star Provisioning - Central Office Terminal (COT) Provisioning
65K510DEP08-1A J-3
5. Typeenable,andpressENTERtoenabletheprivilegedcommands.
6. FromtheEnableprompt,type
configure terminal,andpressENTER.
7. FromtheGlobalConfigurationprompt,provisionthemoduleadministrationstateby
performingoneofthefollowingcommands:
•Type
no slot shutdown <shelf/slot>,andpressENTERtotakeaslotInService
•Typeslot
shutdown maintenance <shelf/slot>,andpressENTERtotakeaslot
OutofService,Maintenance
•Type
slot shutdown <shelf/slot>,andpressENTERtotakeaslotOutofService,
Unassigned
8. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet
<shelf/slot/port>
,andpressENTER.
9. Provisiontheportadministrationstatebyperformingoneofthefollowingcommands:
•Type
no shutdown,andpressENTERtotakeaportInService
•Type
shutdown maintenance,andpressENTERtotakeaportOutofService,Mainte‐
nance
•Type
shutdown,andpressENTERtotakeaportOutofService,Unassigned
Provision the Network Ports
Toconfigurethenetworkportadministrationstates,completethefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet
<shelf/slot/port>
,andpressENTERtoaccesstheEthernetInterfaceConfiguration
prompt.
3. Type
no shutdown,andpressENTERtosettheporttoInService.
4. Repeatsteps2and3foreachportbeingused.
Provision the Ethernet Star
ToconfiguretheTotalAccess5000foraGigabitEthernetStar,completethefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet
<shelf/slot/port>
,andpressENTERtoaccesstheEthernetInterfaceConfiguration
prompt.
3. FromtheEthernetInterfaceConfigurationprompt,type
downlink,andpressENTER.
Thedownlinkcommandenablesdownstreamtreenetworkingontheselectedinterface.