ADTRAN Total Access 5000 - Provision the Line Module; Provision the Line Module Administration Status; Table 6-2. DS3 EFM 4-Port and DS3 EFM 3-Port Administration States

Total Access 5000 Business Services Deployment Guide
6-4 65K510DEP08-1A
Provision the Line Module
ThissectiondetailsprovisioningtheLineModuleservicestate.
Provision the Line Module Administration Status
TheDS3EFM4‐PortorDS3EFM3‐PortcardservicestatemustbesettoISor OutofService,
Maintenance.
NOTE
Ifthecard servicestate is setto Outof Service,Maintenance, normal
operationoccursbutalarmsarenotreported.
Fortraffictopass,theDS3EFM4‐PortorDS3EFM3‐Portmodulemustbeenabled.
Table6‐2displaysthethreeadministrationstatesandshowstheequivalentServiceStatefrom
priorreleases.
Tosetthemoduleadministrationandportadministrationstates,complete
thefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
NOTE
Ifconnectedto the shelfwherethemoduleresides,theshelfnumberis
typically1.
2. FromtheGlobalConfigurationprompt,provisionthemoduleadministrationstateby
performingoneofthefollowingcommands:
•Type
no slot shutdown <shelf/slot>,andpressENTERtotaketheslotInService
•Type
slot shutdown maintenance <shelf/slot>,andpressENTERtotakethe 
slotOutofServiceMaintenance
•Type
slot shutdown <shelf/slot>,andpressENTERtotaketheslotOutof
Service,Unassigned
3. FromtheGlobalConfigurationprompt,typeoneofthefollowingcommands:
Table 6-2. DS3 EFM 4-Port and DS3 EFM 3-Port Administration States
Command Previous Description
no shutdown
InService
Inthe no shutdownstate,trafficpasses
andalarmsaregenerated.
shutdown maintenance
OutofService,
Maintenance
Intheshutdown maintenancestate,traf‐
ficpassesbutnoalarmsaregenerated.
shutdown
OutofService,
Unassigned
Inthe
shutdownstate,notrafficpasses
andnoalarmsaregenerated.