ADTRAN Total Access 5000 - Remove a Link Aggregation Group; Provision Default Network Interface to SM A, Net 1

Appendix A, Link Aggregation Guide - Remove Link Aggregation Provisioning
65K510DEP08-1A A-7
ToredirecttheEVCstoaGigabit‐Ethernetport,completethefollowingprocedure:
1. Fromtherootprompt,type
show evc,andpressENTERtodisplayallEVCsintheTotal
Access5000.
ForanyEVCsthatareconnectedtotheGigabit‐Ethernetport,performthefollowing
stepstodisconnectthemfromtheGEportandconnectthemtotheLAGgroup.
2. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccessthe
GlobalConfigurationprompt.
3. FromtheGlobalConfigurationprompt,type
evc <shelf/slot/index>, andpress
ENTERtoaccesstheEVCInterfaceConfigurationprompt.
4. FromtheEVCI n terface Configurationprompt,type
no connect men-port lag-
group 1/a/1
,andpressENTERtodisconnecttheEVCfromtheLAGgroup.
5. FromtheEVCI n terface Configurationprompt,type
connect men-port gigabit-
ethernet 1/a/1
,andpressENTERtoconnecttheEVCtothenewlycreatedLAGgroup.
6. Type
exit,andpressENTERtoreturntotheGlobalConfigurationprompt.
7. Repeatsteps3‐6asnecessary.
Remove a Link Aggregation Group
Tocreatealinkaggregationgroupandassignphysicalinterfaces,completethefollowing
procedure:
1. FromtheEnableprompt,type
configure terminalandpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
no interface lag-group 1/A/1,and
press
ENTERtodeletethelinkaggregationgroup.
3. FromtheGlobalConfigurationprompt,type
end,andpressENTERtoreturntotheEnable
prompt.
Provision Default Network Interface to SM A, Net 1
Toconfigurethedefaultnetworkinterface,completethefollowingprocedure:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
ethernet default interface
gigabit-ethernet 1/A/1
,andpressENTERtosetthedefaultnetworkinterfacetoSM
A,Net1.
3. FromtheGlobalConfigurationprompt,type
endandpressENTERtoreturntotheEnable
prompt.