ADTRAN Total Access 5000 - Modify a Bonding Group Directly

Section 6, EoTDM Provisioning - Create an EFM Bonding Group
65K510DEP08-1A 6-11
RefertoTable 6‐3 onpage 6‐7forthelistofvariablesfortheEFMbondinggroup.
5. FromtheEFMConf igurationprompt,type
exit,andpressENTERtoreturntothe
ApplicationConfigurationprompt.
Modify a Bonding Group Directly
Tomodifyabondinggroupdirectly,completethefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface efm-group <group_name>,
andpress
ENTERtoaccessthe EFMBondingGroupConfigurationprompt.
3. FromtheEFMGroupInte rface Configurationprompt,typeoneofthefollowing
commandstoaddalinktotheEFMBondingGroup:
•ToprovisiontheDS3EFM4‐Port,type
link <slot/port>,andpressENTER.
•ToprovisiontheDS3EFM3‐Port,type
link <slot/port:channel>,andpress
ENTER.
4. FromtheEFMGroupInte rface Configurationprompt,typeoneofthefollowing
commandstoremovealinktotheEFMBondingGroup:
•ToprovisiontheDS3EFM4‐Port,type
no link <slot/port>,andpressENTER.
•Toprovision theDS3EFM3‐Port,type
no link <slot/port:channel>,andpress
ENTER.
5. FromtheEFMGroupInte rface Configurationprompt,typeexitandpressENTERto
returntotheApplicationConfigurationprompt.