ADTRAN Total Access 5000 - Modify an Existing Bridge; Modify a Bonding Group with EZ-EFM

Total Access 5000 Business Services Deployment Guide
4-10 65K510DEP08-1A
NOTE
Thisinformation is sent to the NetVanta 838 by wa y of an overhead
managementchannel.
OncecompletedandifthemanagementVLANsoftheGigESMandtheNetVanta838are
equivalent,theNetVanta838CommandLineInterface(CLI)canbeaccessedviatheInband
ManagementVLAN.
Modify an Existing Bridge
TherearetwowaystomodifyanexistingEFMbondinggroup.TheEZ‐EFMapplication
allowstheusertoaddorremovealinkto/fromabondinggroupwhilesimultaneouslyspeci‐
fyingthebondinggroupupstreamanddownstreamdatarates.TheEZ‐EFMapplication
automaticallyre‐provisionsalllinksinthe
grouptothenecessarylinkrates,whethertherate
isincreasedordecreased.Thelinksretainandprovidetheprovisioneddatarate.
Thesecondwaytoaddorremovealinkto/fromagroupisbydirectlymodifyingtheEFM
bondinggroupintheEFMBondingGroupConfigurationprompt.Thismethod
doesnot
resultinare‐provisioningofthelinksinthegroup, butcanresultinthelinksnotbeingsetto
theoptimumrates;thegroupnotprovidingthespecifieddatarateiflinksareremoved.
Modify a Bonding Group with EZ-EFM
TomodifyabondinggroupusingtheEZ‐EFMapplication,completethefollowingprocedure:
1. FromtheEnableprompt,type
applicationandpressENTERtoaccesstheapplication
CLIprompt.
2. FromtheApplication Configurationprompt,type
ez-efm 1and pressENTERtostartthe
EZEthernetapplication.
3. FromtheEFMConf igurationprompt,type
modify <group_name> link <slot/
port> upstream <0-250000> downstream <0-250000> active-links-minimum
<1-n>
, andpressENTERtomodifyanexistingEFMBondingGroup.
RefertoTable4‐5forthelistofvariablesfortheEFMbondinggroup.
4. FromtheEFMConf igurationprompt,type
modify <group_name> no-link <slot/
port> upstream <0-250000> downstream <0250000> active-links-minimum
<1-n>
,andpressENTERtoremovelinksfromanexistingEFMBondingGroup.
NOTE
Forthe modifycommand,allparameters mustbe specified, evenifa
particularvalueisnotbeingchanged.
RefertoTable4‐5forthelistofvariablesfortheEFMbondinggroup.
5. FromtheEFMConf igurationprompt,type
exit,andpressENTERtoreturntothe
ApplicationConfigurationprompt.