ADTRAN Total Access 5000 - Page 223

Appendix C, Ethernet OAM Provisioning - Ethernet OAM on the NetVanta 800/8000 Series NCTE
65K510DEP08-1A C-7
Single‐tagCFMservicefors‐tag100:
• Component1VLAN100DownMEPontheMEN‐port
• Component1VLAN100UpMEPontheUNIdefinedbyanEVC‐mapconnectedto
theEVCwiths‐tag100
Single‐tagCFMserviceforc‐tag20towards customer:
• Component2VLAN
20DownMEPontheUNI‐portforcustomerCFMservice
operability.
Double‐tagCFMservicefors‐tag100,c‐tag20destinedfor aProvidernetwork:
• Component2VLAN20UpMEPontheUNI‐portdefinedbyanEVC‐mapconnected
totheEVCwiths‐tag100
9. Type
exit,andpressENTER toreturntotheMDprompt.
10. Type
exit,andpressENTER toreturntotheGlobalConfigurationprompt.
11. AMIPcanbecreatedonaspecificVIDandspecific MDlevelbyenteringtheDefault
MD.TheMIPwillbecreatedonallMEN‐portswiththatVIDsolongthataDownMEP
onthesameVIDdoesn’texistata
equalorhigherlevel.
12. FromtheGlobalConfigurationprompt,entertheEthernetCFMDefaultMDbytyping
ethernet cfm default-domain,andpressENTER.
13. FromtheDefault‐MDComponentprompt,type
component 1 vlan <2-4094>,and
press
ENTERtoconfiguretheMIPcreationsettingsforthespecifiedProviderVLAN.
AprerequisiteforeditingaDefault‐MDComponentisthattheVLANmustalreadybe
definedbyaEVCusingthesames‐tagandintheRunningstate.IfnosuchEVCexists,
thentheMIPrulescannot
beaccessedforthatDefault‐MDComponentVID.
14. FromtheDefault‐MDComponentprompt,type
level <0-7>,andpressENTER.TheMIP
creationwillbeattemptedatthespecifiedMDlevelforthisProviderVID.
15. FromtheDefault‐MDComponentprompt,type
mip-allowed any,andpress ENTERto
allowMIPstobecreatedonthisProviderVID.
16. Type
exit,andpressENTERtoreturntotheGlobalConfigurationprompt.