Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 165
Configure the Drive in Studio 5000 Logix Designer Application Chapter 8
8. Click Create.
The New Module dialog box appears.
9. Configure the new module.
a. Type the module Name.
b. Enter the Logix EtherNet/IP module slot (leftmost slot = 0).
c. Select an Ethernet Address option.
In this example, the Private Network address is selected.
d. Enter the address of your EtherNet/IP module.
In this example, the last octet of the address is 32.
e. Click Change in the Module Definition area.
The Module Definition dialog box opens.
10. To close the Module Definition dialog box, click OK.
To Next Page
Loading...
