164 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 8 Configure the Drive in Studio 5000 Logix Designer Application
5. Click Finish.
The new controller appears in the Controller Organizer under the I/O
Configuration folder.
6. Right-click I/O Configuration in the Controller Organizer and choose
New Module.
7. By using the filters, check Communication and Allen-Bradley, and select
1756-EN2T, 1756-EN2TR, or 1756-EN3TR as appropriate for your
hardware configuration. In this example, the 1756-EN2T module is
selected.
IMPORTANT If your project includes a ControlLogix or GuardLogix® 5570 controller, you need
to add an EtherNet/IP communication module to your Bulletin 1756 chassis
and configure it for use in your application.
• For ControlLogix 5570, and GuardLogix 5570 controllers, go to step 6
.
• For CompactLogix 5370, Compact GuardLogix 5370, CompactLogix 5380,
ControlLogix 5580, or GuardLogix 5580 controllers, go to step 13
.
Refer to the EtherNet/IP Network Configuration User Manual,
publication ENET-UM006
for more information on EtherNet/IP modules.
CompactLogix 5370 Controller
ControlLogix 5570 Controller
To Next Page
Loading...
