Important:
When you reset to factory defaults, the switch or stack retains the stack operational mode,
the last reset count, and the reason for the last reset; these three parameters are not reset
to factory defaults.
Viewing the agent and image software load status using
ACLI
The command
described in this section is used to display the currently loaded and operational
software status for agent and image loads, either individually or combined, for an individual
switch or a stack.
show boot command
The show boot command displays the currently loaded and operational software load
status.
The syntax for the show boot command is
show boot [diag] [image]
Run the
show boot command in User EXEC command mode.
Variable definitions
The following table describes the optional parameters you can enter with the show boot
[diag] [image] command.
Variable Value
diag Displays only information for the agent load.
image Displays only information for the image load.
Important:
When the
currently loaded and operational software status is displayed for a stack, the unit
number is replaced by the word All.
System configuration using ACLI
100 Configuration — System April 2011
To Next Page
Loading...
