Variable Value
EndHour Specifies the hour of the particular day when to end the
daylight savings time.
EndMinutes Specifies the minute of the particular hour when to end
the daylight savings time.
Enabled Enables or disables day light saving time.
Important:
Before you enable daylight saving time, configure
the feature attributes.
Configuring recurring daylight saving time using EDM
Use this procedure to configure the daylight saving time start and end times for a single
occurrence or to recur yearly.
Procedure steps
1.
From the navigation tree, double-click Edit.
2.
In the Edit tree, double-click SNTP/Clock.
3. In the work area, click the SummerTimeRecurring tab.
4. Select the Recurring check box to enable recurring daylight saving time for the
switch.
OR
Clear the Recurring check box to disable recurring daylight saving time for the
switch.
5. In RecurringStartMonth, make a selection from the drop-down list.
6. In RecurringStartWeek., click a button.
7. In RecurringStartDay, make a selection from the drop-down list.
8. In RecurringStartHour, make a selection from the drop-down list.
9. In the RecurringStartMinute dialog box, type a value from 0 to 59.
10. In RecurringEndMonth, make a selection from the drop-down list.
11. In RecurringEndWeek, click a button.
12. In RecurringEndDay, make a selection from the drop-down list.
System configuration using Enterprise Device Manager
280 Configuration — System April 2011
To Next Page
Loading...
