Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click Chassis .
3. In the Chassis tree, double-click Switch/Stack.
4. In the work area, click the Stack Numbering tab.
5. To select a switch unit, click a unit row.
6. In the unit row, double-click the cell in the New Unit Number column.
7. Select a value from the list.
8. Click Apply .
A warning message appears indicating that initiating the renumbering of switch units
in a stack results in an automatic reset of the entire stack.
Variable definitions
Use the information in the following table to change the unit numbers of switches in a stack.
Variable Value
Current Unit Number Indicates the current switch numbering sequence.
New Unit Number Specifies the updated switch numbering sequence.
Interface port management using EDM
Use the information in this section to display and manage switch interface port
configurations.
Viewing switch interface port information using EDM
Use this procedure to display switch interface port configuration information.
Interface port management using EDM
Configuration — System April 2011 229
To Next Page
Loading...
