Setting port speed
To set port speed and duplexing using
ACLI, see the following sections:
•
speed command on page 140
• default speed command on page 141
• duplex command on page 141
• default duplex command on page
142
speed command
The
speed command sets the port speed.
The syntax for the speed command is
speed [port <portlist>] {10 | 100 | 1000 | auto}
Run the speed command in Interface Configuration command mode.
The following table describes the variables for the speed command.
Table 57: speed variables
Variables Description
port <portlist> Specify the port numbers to configure the speed. Enter the port
numbers you want to configure.
System configuration using ACLI
140 Configuration — System April 2011
To Next Page
Loading...
