default lldp tx-tlv dot3 command
The default lldp
tx-tlv dot3 command sets the optional IEEE 802.3 organizationally-
specifc TLVs to their default values. The syntax for the default lldp tx-tlv dot3
command is
default lldp tx-tlv [port <portlist>] dot3 [mac-phy-config-status]
[mdi-power-support] [link-aggregation][maximum-frame-size]
Run the default lldp tx-tlv dot3 command in Interface Configuration command
mode.
The following table describes the variables for the default lldp tx-tlv dot3
command.
Table 86: default lldp tx-tlv dot3 command variables
Variables Description
port <portlist> The ports affected by the command.
mac-phy-config-status
The MAC/Phy Configuration/Status TLV (default value
is false: not included).
mdi-power-support
The power via MDI TLV. This TLV is enabled by
default.
link-aggregation
The link aggregation TLV (default value is false: not
included).
maximum-frame-size
The maximum frame size TLV (default value is false:
not included).
default lldp tx-tlv med command
The default lldp tx-tlv med command sets default values for the optional
organizationally specific TL
Vs for use by MED devices to be included in the transmitted
LLDPDUs. The syntax for the default lldp tx-tlv med command is:
default lldp tx-tlv [port <portlist>] med [med-capabilities]
[extendedPSE] [inventory] [location] [network-policy]
The default lldp tx-tlv med command is in the config-if command mode.
The following table lists the variables for the default lldp tx-tlv med command.
Configuring LLDP using ACLI
Configuration — System April 2011 173
To Next Page
Loading...
